Settings For Aquacontact - Franke ZAQUA091 Instrucciones De Montaje Y Uso

Stopping thermal disinfection
10.18 Press and hold the RESET key.
10.19 Additionally press the
• The LED in the sensor flashes with 1s intervals
• If the fitting is in the exposure phase, the cooling phase starts immediately.
• If the fitting is in the cooling phase, the solenoid valves are closed immediately.
Thermal disinfection emergency-stop
10.20 Press key
• The LED in the sensor does not flash.
Exiting from TD Mode
10.21 Press keys RESET and
• The LED flashes 4 × briefly.
or
if thermal disinfection is being performed, wait for the end of the disinfection process.
Resetting default factory settings (Reset)
10.22 Press the RESET key for at least 3 s.
• The system now has the factory settings again.
• The LED flashes briefly 4 × short (2 × in succession).

11. Settings for AQUACONTACT

☞
Important!
Activate the fitting for remote control (see
Normal Mode
Start solenoid valve test
Warning!
When opening the solenoid valve cartridge for hot water, there is the risk of scalding.
11.1 Press the
• One by one, the solenoid valve cartridges open briefly.
OFF key within 2s.
OFF 2 times.
OFF.
ON key.
chapter 7.).
15