Urinal Settings - Franke ZAQUA091 Instrucciones De Montaje Y Uso

12. Urinal Settings

Triggering flushing
12.1 Press the
• Water flows for the set flushing duration.
Switching 24 hour flushing on/off
☞
Flushing is factory-set to 24 hours.
12.2 Press and hold the RESET key.
12.3 Additionally press the
• The LED in the sensor of the fitting flashes:
– 4 x short: 24 hour flushing is switched on.
– 2 × long: 24 hour flushing is switched off.
12.4 Wait 10 seconds.
• The system exits from the setting mode.
Resetting default factory settings (Reset)
12.5 Press the RESET key for at least 3 s.
• The system now has the factory settings again.
• The LED in the sensor of the fitting flashes:
– 4 × short, 1 × long, 3 × short, 1 × long, 3 × short
• The fitting is in Power-Up mode:
– Any detected objects are displayed by the LED in the sensor of the fitting.
– There is no minimum dwelling time, i.e. flushing always occurs after the end of
detection, independent of the time spent within the detection area.
☞
Power-Up mode is stopped automatically after 3 minutes. The fitting is now in
normal operation.
ON key.
OFF key within 2s.
21