Truper CAZ-EL-4-1/2N2 Instructivo página 20

Cutting depth adjustment
• Loosen the cutting depth control lever by moving it downwards.
• Fasten the base and lift the housing until the blade shows from the base onto the desired depth. Use the depth guide as
reference.
• Press the cutting depth control lever with an upward movement to stop the housing from move in when you cut.
• The cutting depth may go up to 1.2"
CAUTION • In order to avoid accidents the cutting depth must be equal as the work piece thickness or to stick out
just a couple of inches.
Cutting depth
guide
Cutting angle setup (bevel cut)
• Loosen the cutting angle bracing knob.
• Fasten the base. Turn the housing until the blade reaches the desired angle.
• Tighten the cutting angle bracing knob to stop he housing from moving while cutting.
• The tool makes cuts from 0° up to 45°
The tile and masonry saw is a hand held power tool with double insulation. Is used with a diamond blade designed to cut:
marble, ceramic, tile and similar materials.
CAUTION
This tool is not designed to cut metal or wood.
Switching ON
• Intermittent operation:
Connect the plug into the outlet.
Press switch (A) to start the saw.
To stop just release the switch.
• Continuous operation:
Connect the plug into the outlet.
Press switch (A) and lock it by pushing the continuous use button (B).
To stop, press and then release the switch.
8
ENGLISH
Cutting depth
control lever
Cutting angle
bracing knob
Start up
Base
Start up
A
B