Hkoenig kbp40 Manual De Instrucciones página 12

The ice shovel is blocked.
indicator
blinks
The ice The ice tray is not in the right position.
maker
stops
working.
The ice The "ice full" condition can not be
basket is detected as the infrared light module is
full but the interfered by the sunlight.
" "
indicator
does not
illuminate.
The ice Making ice takes too much time.
collects
together.
The water in the water reservoir is of too
low temperature.
The The ambient temperature or water
ice-making temperature is too high.
cycle
seems
normal but
no ice is
Refrigerating system leaks
produced.
Refrigerating system blocks
Poor 1.
ice-making
2.
result
high.
3.
high.
Poor heat dissipation.
The water temperature is too
The ambient temperature is too
Please remove the ice if the ice shovel is blocked by
ice, otherwise, call customer service for consultation.
1. Remove the ice in the ice tray and press the
" " key to restart the appliance.
2. Call Customer Service if the appliance still can
not work after restart.
Unplug the appliance and move it to a place which is
not exposed to the sunlight, then plug the appliance
and activate it again.
Stop making ice and restart the ice-making cycle after
the ice melts.
Fill the water reservoir with water ranges between 8℃
and 25℃.
Start the ice-making cycle at a environment with an
ambient temperature less than 32°C and fill the water
reservoir with some cold water.
Call customer service
Call customer service
1. Leave an 8-inch (20cm) clearance on all sides
of the ice maker for proper ventilation.
2. Fill the water reservoir with water ranges
between 8℃ and 28℃.
1. Operate the ice maker at a environment with
an ambient temperature between 10℃ and 32℃.