mspa Nest Manual Del Propietário página 15

Cleaning The Spa Tub
If dirt is visible in the water or if the water becomes cloudy and the correct water chemistry does not clear it up, change the water and clean the spa tub. See
the "Spa tub drainage" section on how to drain the spa. While empty, clean and/or replace the filter cartridge. Use a sponge and mild soap solution to wipe
away any soil or stains on the inside of the spa wall. Rinse thoroughly before refilling with clean water.
IMPORTANT: Do not use steel wool, hard brushes or abrasive cleaners.
Spa Tub and Air Bladder Repair
Use the enclosed repair patch to repair any puncture:
1. Clean and dry the area to be repaired thoroughly
2. Apply the glue to the PVC patch and quickly attach it onto the damaged surface. (Glue is not included)
3. Smooth the surface to remove any air bubbles and allow it dry for 5-10 minutes
NOTE: Glue is not included.
1
Storage and Preparation for Future Use
1. Drain and clean the spa by following the "Drainage" and "Spa Cleaning" sections.
2. Refer to the instructions to deflate the spa tub and air bladder.
3. Make sure all the spa components and accessories are thoroughly clean and
dry before storage. Air-dry the spa tub in the mild sun for an hour before folding.
4. Fold the spa tub loosely and avoid any sharp corners to prevent damage or
leakage to the spa liner.
5. Prepare new additional cartridge for next time use.
6. Store the spa and accessories in a dry, temperature-controlled environment,
between 0°C and 40°C (32°F - 104°F). We recommend storing the spa with
desiccant.
7. The original packaging is recommended for storage.
8. After long-term storage, fill the spa with clean water and sanitizer, and turn on the
FILTER for at least 1 hour before use.
Deflation Instructions
Spa deflation
1. Unscrew the valve completely to deflate the spa.
2. Once deflation is completed, replace the cap.
Spa Bladder Deflation
1. Open the valve cap to deflate the bladder. For quick deflation, insert the straw (included in the repair
kit) into the valve.
2. Once the deflation is completed, re-place the cap back.
2
pin hole pin hole
15
3