Steren AMP-010 Manual De Instrucciones página 14

CONTROLS
PORTABLE AMPLIFIER
1.- REC OUT: Connects to external device for recording.
2.- MIC: Auxiliary input or wire microphone.
3.- MIC VOL: Wired microphone volume control. MAX + increases
the volume and MIN - lowers the volume.
4.- BAT LOW LED: This LED turns on when the battery is discharged.
5.- POWER: Turn on LED indicator.
6.- WM VOL: Wireless microphone volume control.
7.- RF: RF signal LED indicator.
8.- Antenna.
9.- CHARGE LED: This LED turns on when the back-up battery is
charging. This LED turns off when the baterry is fully charged.
10.- TONE: tone control. High: in this position, the tone increase.
Low: in this position, the tone decrease.
11.- Holder.
12.- Holes to hang the amplifier in a wall.
13.- ON/OF/Charge Switch. ON: Turn on OFF: Turn off. CHARGE:
In this position the battery is charging, if the amplifier is connected
to an electrical contact.
14
TOP VIEW
10
1 2 3 4
FRONT VIEW
REAR VIEW
9 8
5 6