Steren AMP-010 Manual De Instrucciones página 16

INSTRUCTIONS
1.- Turn the Tone knobs to middle position, before to turn the equipment on. Then set the volume
level to minimum, later you can adjust it in accord to your necessities.
2.- If you want to connect a second microphone use the MIC input jack.
3.- To plug a recorder or a power amplifier, use the REC OUT jack
4.- Open the receiver is antenna.
5.- Plug the power cord into an electrical outlet.
When you use only the portable amplifier mode be sure that the back-up battery is fully charged, you
' ' connect the amplifier to an electrical contact and move the switch in Charge position, the Led "Charge"
turns on. This LED turns off when the battery is charged. When the battery is discharged, the LED indicator
"LOW BATT" turns on, then it is necessary to charge the back-up battery.
6.- Turn on the amplifier.
7.- Turn on the wireless microphone then begin speaking and adjust the volume level according your needs.
8.- When not using the devices turn off the amplifier and turn off the microphone and remove the
microphone´s battery and disconnect the amplifier.
SPECIFICATIONS
Input: 110-240V~ 50/60Hz 50W
Battery: 12V - - - 1.2Ah
Power output: 35Wrms
Frequency response: 50-12000Hz
Carrier frequency: 160-270 MHz
Sensitivity: 10dBµV
Product design and specifications are subject to change, without notice.
16
Microphone
Input: 9V - - - (square battery)
Frequency response: 40Hz to 16kHz
Total harmonic distortion (THD): <0.5%
Nominal consumption: 432 Wh/day
Stand-by power consumption: 240 Wh/day