Publicidad
Idiomas disponibles
Idiomas disponibles
Dear Customer,
Congratulations on your choice. We are certain that this
modern, functional and practical device made with first rate
quality materials will fully satisfy your requirements.
Please read all the sections in this INSTRUCTION MANUAL
before using the hood for the first time in order to obtain
maximum performance from the device and avoid faults
which may arise from incorrect use as well as minor problem
solving.
For optimal performance, the external duct should not exceed
FOUR METRES, have more than two 90 ° angles and its
diameter should be at least Ø120.
Safety Instructions
•Disconnect
the
performing any work on the interior,
e.g. during cleaning or maintenance.
•The excessive accumulation of grease
in the hood and metal filters may cause
dripping and fire risks, therefore it is
necessary to wash the inside of the
hood and the metal filters at least once
a month.
•This device can be used by children
aged 8 and over and persons with
reduced physical, sensory or mental
capabilities or lack of experience and
knowledge, if they have been given
supervision or proper training in the
safe use of the device and if they
understand the dangers involved.
Children should not play with the
device. Cleaning and maintenance
should be performed by the user and
not by unsupervised children.
•
The
regulations
installations must be complied with.
device
before
for
electrical
•Check that the power voltage and
frequency match those indicated on the
label located on the inside of the hood.
A suitable earth must be connected
(except for Class II devices, marked
with
on the technical data plate).
•For installation, a connection method
isolated from the fixed installation
should be incorporated, in accordance
with installation regulations (adjusted
to the strength to be endured and
with a minimum opening between the
contacts of 3mm) under overvoltage
category III conditions, for the
emergency shutdown, cleaning or light
replacement. In no event should the
earth pass through this switch. This
switch can be replaced with a plug if it
is accessible in normal use.
•If the power lead is damaged it must
be replaced by the manufacturer, its
after-sales service or by qualified
personnel in order to avoid potential
danger.
• Ventilation regulations must be com-
plied with.
• Air should not be extracted by ducts
used to expel fumes from equipment
powered by gas or other fuels.
Publicidad
