Publicidad
EMISSION WARRANTY
(5) Notwithstanding the provisions of Subsection (4) above,
warranty services or repairs must be provided at all A-iPower
distribution centers that are franchised to service the subject
engine/equipment.
(6) The owner must not be charged for diagnostic labor that
leads to the determination that a warranted part is in fact
defective, provided that such diagnostic work is performed
at a warranty station.
(7) A-iPower is liable for damages to other engine/equipment
to other engine/equipment components proximately caused
by a failure under warranty of any warranted part.
(8) Throughout the emissions warranty period defined in
Subsection (b)(2), A-iPower must maintain a supply of
warranted parts sufficient to meet the expected demand for
such parts.
(9) Any replacement part may be used in the performance of
any warranty maintenance or repairs and must be provided
without charge to the owner. Such use will not reduce the
warranty obligations of A-iPower. maintenance or repairs and
must be provided without charge to the owner. Such use will
not reduce the warranty obligations of A-iPower.
(10) Add-on or modified parts that are not exempted by the
Air Resources Board may not be used. The use of any
non-exempted add-on or modified parts will be grounds for
disallowing a warranty claim. A-iPower will not be liable to
warrant failures of warranted parts caused by the use of a
non-exempted add-on or modified part.
(11) A-iPower issuing the warranty shall provide any
documents that describe that manufacturer's warranty
procedures or policies within five working days of request by
the Air Resources Board.
(d) Emission Warranty Parts List for exhaust (for all
displacements).
(1) Fuel Metering System
(i) Carburetor and internal parts (and/or pressure regulator or
fuel injection system).
(ii) Air/fuel ratio feedback and control system.
(iii) Cold start enrichment system.
(2) Air Induction System
(i) Controlled hot air intake system.
(ii) Intake manifold.
(iii) Air filter.
(3) Igniti on System
(i) Spark Plugs.
(ii) Magneto or electronic ignition system.
(iii) Spark advance/retard system.
(4) Exhaust Gas Recirculation (EGR) System
(i) EGR valve body, and carburetor spacer if applicable.
(ii) EGR rate feedback and control
(5) Air Injection System
(i) Air pump or pulse valve.
(ii) Valves affecting distribution of flow.
(iii) Distribution manifold.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
(6) Catalyst or Thermal Reactor System
(i) Catalytic converter.
(ii) Thermal reactor.
(iii) Exhaust manifold.
(7) Particulate Controls
(i) Traps, filters, precipitators, and any other device used to
capture particulate emissions.
(8) Miscellaneous Items Used in Above Systems
(i) Electronic controls.
(ii) Vacuum, temperature, and time sensitive valves and
switches.
(e) Emission Warranty Parts List for Evap less than or equal
to 80cc.
(i) Fuel Tank.
(f) Emission Warranty Parts List for Evap greater than 80cc.
(1) Fuel Metering System
(i) Fuel Tank.
(2) Miscellaneous Items Used in Above Systems
(i) Fuel caps, valves, canisters, filters, vapor, hoses, clamps,
connectors, belts, and and assemblies.
A-iPower will furnish with each new engine/equipment written
instructions for the maintenance and use of the engine/
equipment by the owner.
A-iPower's only liability shall be the repair or replacement of
part(s) as stated above in no event shall A-iPower be liable for
any incidental or consequential damages.
23
Publicidad
