Publicidad
Step 10
Step
å
Push four CROSS-SLOTTED DOWELS (6) into
the MOLDINGS (H).
å
NOTE: The holes in the CROSS-SLOTTED DOWELS
should be pointed towards the holes on the edges
of the MOLDINGS.
å
Fasten the UPPER FRAMES (O) to the MOLDINGS (H).
Tighten four 1-3/4" HEX HEAD SCREWS (13) using
the L-WRENCH (9).
å
Fully tighten all of the SCREWS.
6
H
13
427971
H
www.sauder.com/service
13
1- 3/4" HEX HEAD SCREW
(4 used in this step)
Page 15
Publicidad
