Publicidad
Step 15
Step
å
The following instructions show your unit being fastened to wall studs. If you are not fastening your unit to wall studs,
go to the next step now.
å
1
- Locate the center of two studs in your wall near your unit and mark them with a pencil.
st
å
2
- Drill a 1/8" hole on each of the marks and into the studs in your wall.
nd
å
3
- Fasten the unit to the wall. Use the LONG SCREWS through the other end of the SAFETY STRAPS and into
rd
the 1/8" holes.
Mark and drill
a 1/8" hole into
the wall stud.
1
st
96
(2 used)
Page 20
Electric drill with 1/8" bit
2
nd
3
rd
www.sauder.com/service
427971
Publicidad
