Topcom KS-4262 Manual De Usuario página 4

Instruction manual
• Batteries (battery pack or batteries installed)
shall not be exposed to excessive heat such
as sunshine, fire or the like.
• The AC mains adaptor is used as the
disconnect device, the disconnect device
shall remain readily operable.
PARTS DESCRIPTION
Parent unit
1. Charge indicator LED
2. Power / Pair indicator LED
3. Outdoor volume indicator LED
4. Screen
5. Menu button
6. OK button
7. Mode button
8. Intercom button
9. Microphone
10.
Up / Brightness + button
11.
Down / Brightness -
button
12.
Left/ Volume + button
13.
Right / Volume - button
14.
Antenna
15.
Power on/off button
16.
Power input
17.
Support frame
4
Baby unit
1. Pair button / Night light switch
2. Power / pair indicator LED
3. Infrared LED
4. Camera
5. Microphone
6. Base
7. Antenna
8. Speaker
9. Temperature probe
10. Power input
GETTING STARTED
• Take the appliance and accessories out the box. Remove the
stickers, protective foil or plastic from the device.
• Place the appliance on a stable surface and make sure there is
10 cm. free of space around the appliance.
• Connect both the parent unit and the baby unit to the provided
power adaptors. On the baby unit a blue LED will light up.
• Press the power button of the parent unit to switch it on. Press it
again to switch it off.
• NOTE: Charging the parent unit fully before use is recommended.
This will allow the unit to operate on battery in the event of a
power failure.
USE
Pairing the units
1. Press and hold the pair button on the baby unit until the pair
indicator LED flashes.