Cembre B1350-C Manual De Uso Y Mantenimiento página 7

To replace the battery, remove it by pressing the release button (7) (Ref. to Fig. 1), then insert the
new battery, sliding it into the guides until it locks.
The display shows the operational parameters of the tool; to customise them proceed as described
in § 2.7.
Select the appropriate die set for the connector.
When introducing or changing dies, the battery must fi rst be removed from the tool.
Operate the tool to advance the ram (11) 15-20 mm (0.6 - 0.8 in.) so to easily press release pin
(14) (Ref. to Fig. 2) then remove the battery.
Keep release pin (14) depressed and insert one die into the seat on the ram until it is locked by
retaining pin (15).
Keep release pin (12) depressed and insert one die into the upper seat of the tool head until it
is locked by retaining pin (13) then insert the battery.
Insert the conductor into the connector (Ref. to Fig. 3).
Position the connector between the dies and ensure the correct location of the crimp (Ref. to
Fig. 4).
NOTE
: when more compression is
required, proceed according to the
sequence and direction indicated
in the fi gure, uniformly spacing the
compressions.
2.2) Die advancement
Press operating button (4) (Ref. to Fig. 4) to activate the motor-pump and advance the lower die.
To halt the advancement, release operating button (4) and the motor will cut out.
Make sure the dies are exactly positioned on the desired crimp point otherwise re-open dies
following instructions as per § 2.4 and reposition the connector.
2.3) Compression
By keeping operating button (4) pressed, the motor continues to operate: the ram will gradually
move forward until the two dies touch.
The motor will stop automatically when the set pressure has been reached.
To perform proper compression, press and hold the operating button (4) until the motor
stops automatically.
7
terminal
2
1
2
1
connector
1
2