ProMed EMT-4 Instrucciones De Empleo página 52

49
DISPLAY GUIDE
Program display
Frequency display
Pulse width
display
Intensity,
channel 1
When the unit is switched on, all readouts are active for a short
time before the unit switches to standby (wait) mode.
Pause
Function check
Treatment time
Intensity,
channel 2
PROGRAM SELECTION...
Preset programs P-01 to P-11 and memory function
1. After attaching the electrodes, press the „ON/OFF" button to
switch on the unit.
2. Keep pressing the "Program" button until one of the preset pro-
grams (P-01 to P-11) is shown on the display.
3. Press the "Set" button. The time will flash on the display, " ´ "
for minutes and " `` " for seconds. Use the "+" or "–" buttons
to enter the desired treatment duration (20 minutes to 2 hours) in
steps of ten minutes.
4. Press the "Select" button 2 times. The intensity display "CH1"
will start to flash. Use the "+" or "–" buttons to enter the desired
value (from 1 to 50). Setting the intensity will simultaneously start
the unit. In the top right of the display, the clock symbol will be-
gin to flash. Press the "Select" button once more. The intensity
display "CH2" will start to flash. Once again, use the "+" or "–"
buttons to set the desired value.