ProMed EMT-4 Instrucciones De Empleo página 54

51
PROGRAM SELECTION AND STARTING THE TREATMENT
Programmable programs P-C1 and P-C2
After attaching the electrodes...
Press the "ON/OFF" button to switch on the unit.
1.
Keep pressing the "Program" button until the programmable
2.
programs (P-C1 or P-C2) are shown on the display.
Press the "Set" button once. In the display, the frequency (Hz)
3.
and "SET" will start to flash. Use the "+" or "–" buttons to
enter the desired value (1 Hz to 200 Hz).
Press the "Set" button. In the display, the pulse width (µS) and
4.
"SET" will start to flash. Use the "+" or "–" buttons to enter the
desired value (from 30 µS to 400 µS) in steps of ten.
Press the "Set" button once more. The time will flash on the dis-
5.
play. Use the "+" or "–" buttons to enter the desired treatment
duration (1 minute to 24 hours).
Press the "Set" button to confirm and then press the "Select"
6.
button 2 times. The intensity display "CH1" will start to flash.
Use the "+" or "–" buttons to enter the desired value (from 1 to
50). Setting the intensity will simultaneously start the unit. Press
the "Select" button once more. The intensity display "CH2" will
start to flash. Once again, use the "+" or "–" buttons to set the
desired value. Fast adjustment protection will be activated and
stops at intensity level 15 when the intensity increases rapidly.
To complete the settings, press the "Select" button once more.
7.
If you want to change the intensity during treatment, press
8.
the "Select" button again and adjust the intensity as required
using the "+" or "–" buttons.