Zeegma Zonder Robo Next Manual De Usuario página 8

EN
Dustbin (see fig. 4):
1.
Main cover of dustbin
2.
Side cover of dustbin
3.
HEPA filter
4.
Sponge filter
Water tank (see fig. 5):
8.
Water inlet hole
9.
Water tank
Remote control (see fig. 6):
12.
Return to docking station
13.
Go forward
14.
Turn right
15.
Suction power adjustment
16.
Edge vacuuming
17.
On/off
3. How to assemble (see fig. 7):
•
Press the water tank release key, and then remove the tank.
•
Fix side brushes, left and right (L / R).
•
Before you use the device, remove the protective strip.
4. How to use:
How to store and charge:
•
Place the docking station by the wall, on a flat surface. Leave some free space around
the station, that is 0,5m to the left and right, and 1,5m before the station (see fig. 8).
•
Supply power to the docking station and plug in (see fig. 8).
•
Place the device on the floor. Turn on the main switch (see fig. 9).
Caution! Any interference with the operation of the device (lifting, moving, remote
control of the device, etc.) may disrupt the cleaning process and cause errors in the
positioning of the device in the room.
If the device needs to be stopped, press the pause button (2, fig. 2). Do not change the
position of the device.
5.
Preliminary filter
6.
Upper part of dustbin
7.
Lower part of dustbin
10.
Mop
11.
Tank release key
18.
Pause/Start
19.
Turn left
20.
Reverse key
21.
Suction power adjustment
22.
Spot vacuuming