doppler 411557 Instrucciones De Montaje Y Uso página 7

GB
Ac tive Mit telmast
Assembly and inst r uc tion
manual
Carefully read through the com-
plete instruction manual, particu-
larly the safety notes. Failure to
heed this instruction may result in
severe injury or damage to the product. Hold
onto the instruction manual for future refer-
ence or in order to pass them onto third par-
ties.
Your safet y
Please observe the following safe-
ty notes. The manufacturer is not
liable for damage as the result of
failure to comply.
Only use the sun shade with sufficient ballast-
ing (see Technical data).
Always place the product on a firm and lev-
el surface.
Use a stable base for the sun shade.
The product should only be erected by a com-
petent adult.
When opening and closing the sun shade,
please make sure to keep your hands outside
of the folding mechanism.
Close the sun shade in case of approaching
wind or storm. Otherwise, it could be caught
by a gust and overturned and inflict damage
in the process or sustain damage as a result.
Never ignite an open fire in the vicinity of or
underneath the sun shade. The shade may
bolt fire or be damaged by airborne sparks.
The sun shade is not a children's toy. Children
could trap their fingers. Also, the sun shade is
heavy and could injure children if it tips over.
Do not hang anything on the lateral braces of
the sun shade or even use them for chin-ups.
The sun shade can protect your skin from di-
rect UV radiation, but not from reflected UV
rays. For this reason, please also use a cos-
metic sun block.
In order to protect the sun shade from exces-
sive strain, close the shade in the event of rain
or snow and secure it with a tie strap.
The cover is not suitable for machine wash-
ing, dry cleaning or bleaching.
8
Do not use aggressive chemical cleaning
agents or fluids, solvents, abrasive substanc-
es or objects, bleaching agents, high-pres-
sure cleaners or strong cleaning products.
Please note the information on the care label
sewn into the sun shade.
Intended use
The sun shade is suitable for providing pro-
tection against direct UV radiation. It is not in-
tended to provide protection against rain or
snow.
Set ting up the shade
To secure the sun shade, you must use the
following shade base: for the model
200
240/210
180x120
200x130/200x120
1. Place the sun shade base in the desired
location.
2. Release the locking mechanism a on the
bottom pole (see figure A).
3. Let the shade slide at least 10 cm into the
bottom pole. Tighten the locking mech-
anism a by turning it clockwise (see fig-
ure B).
4. Place the shade pole in the sun shade
base and fix it in place; see the instruction
manual for the sun shade base.
Opening the shade
Make sure that the shade is adequately sup-
ported; that is, that the weight of the sun
shade base is sufficient (see "Technical da-
ta").
1. Open the shade slightly by hand (see fig-
ure D).
2. Push the slide handle b up until it audibly
locks into place (see figure E + F).
30 kg
40 kg
40 kg
40 kg