Casselin CLVAC Manual De Instrucciones página 17

3. TRANSPORT, PACKAGING AND STORAGE
3.1 Inspection after transport
Verification of the absence of damage and the integrity of the device must be carried out upon receipt of the
package. In case of identification of damage due to transport, refuse or accept the product delivered only
under reserve*. A complaint detailing the defects observed must then be made. The perception of damages
is only possible in the event of a complaint formulated within the time limits provided, ie 24-48 hours at the
most.
*written on the right paper or digital delivery from the carrier.
3.2 Packaging
The packaging of the device must be kept in the event of a move, or for a return to the after-sales service.
The interior and exterior packaging must be completely removed before using the device. The standards in
force in your country concerning the protection of the environment must be respected before destroying the
packaging.
3.3. Storage
ATTENTION
The storage of the device in stock can be done but only in its original closed packaging.
Storage can be carried out under these conditions:
• Storage in a dry, non-humid place
• Sheltered from the sun
• Control of stock for more than 2 months (general condition of the device and all the elements that make it
up)
• No material shaking
• Storage in a closed room and not outside.
4. INSTALLATION AND USE
4.1 Safety instructions
ELECTRICAL HAZARD
Danger due to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into an appliance that is in operation or still hot.
• The device must be properly connected and comply with the regulations in force.
WARNING
While operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use non-original spare parts.
ELECTRICAL HAZARD
Danger due to electric current!
If incorrectly installed, the device can be dangerous and cause injury. Before any installation, check the data
of the electrical network. Connect the device only when there is compliance. The device must be unpacked
and fully checked before connection by a professional.
4.2 Setup
The installation of the dishwasher must be carried out by qualified and expert personnel: by personnel from
the manufacturer or by an authorized installer, or by personnel with similar qualifications.
EN