Casselin CLVAC Manual De Instrucciones página 22

Washing
Check that the temperature of the water in the water heater and that in the tank has indeed been reached
(the temperature of the water heater and the tank displayed on the left side of the screen is fixed without
flashing).
To wash, simply insert the basket filled with dirty dishes into the dishwasher and close the hood. If the
appliance has been set with the automatic start of the cycle, there is nothing else to do, except press the
button .
During the wash, it is possible to fill another basket for the next wash.
During washing, the display alternately shows the display of the measured water temperatures and the
selected wash cycle, alternated with the display of the washing phase in progress, the estimated remaining
time until the end of the cycle , and a diagram showing the evolution of the washing phase (inner circle) and
rinsing (outer circle).
At the end of washing, the appliance emits an acoustic signal.
You can then open the hood, remove the basket with the clean dishes, load the dishwasher with a basket of
dirty dishes and carry out a new wash cycle.
If the boiler standby device has been activated, at the end of the washing phase the appliance will not proceed
with the cycle if the temperature of the boiler does not correspond to that selected. The cycle restarts with
rinsing as soon as the temperature is reached.
after washing
1- Empty the tank by removing the plug located in the tank itself. If the dishwasher is equipped with an
automatic drain pump, press the button
2- Switch off the device by pressing the power button
3- Close the wall main electrical switch
4- Close the water supply tap
5- Check and properly clean the backwash filters.
NOTICED
The appliance is equipped with a safety system in case of overheating. In the event of tripping, unplug the
appliance and allow it to cool. If this protection system activates regularly, it is essential to contact your
retailer.
After automatic shutdown, the device can only be put into operation by pressing the Reset button on the back
of the device. To do this, wait for the temperature to drop, press the Reset button.
.
for 3 seconds
EN