Emos P56501 Manual De Instrucciones página 3

Acoustic signalisation: >85 dB at a distance of 3 m
Power supply: 1× 9 V (battery life 1 year)
Power consumption: <10 μA standby mode, <30 mA alarm mode
Smoke detection sensitivity: 0.109 to 0.160 dB/m
Dimensions: 90 × 35 mm
Weight: 65 g
Detector Description
A – LED
B – Main button
C – Loud siren
Installation
The installation must be performed by a qualified person.
The person performing the installation is responsible for installing the product in accordance with
valid regulations.
When in doubt, leave the installation to a qualified professional.
The detector is not designed for use in camper vans.
Ideally, a smoke detector should be installed in every room of the house with the exception of kitchens,
bathrooms and garages.
Each floor of the house, including the stairs, should have at least one smoke detector installed.
The smoke detector should be located in a place where you can hear it even when you are sleeping,
e.g. in the hall in front of the bedroom.
Install the detector on the ceiling of each bedroom and the hall in front of the bedroom.
If the hall is longer than 9 m, install a detector on both ends.
If you have a multi-storey house, install the detector in the same manner on each floor.
You will be protected even against smoke rising up the stairs from the bottom floor.
In the cellar, install the detector on the ceiling at the bottom of the stairs.
Do not install the detector in bathrooms or kitchens; the steam from water or food could cause
false alarms.
In the garage, the alarm could be triggered by the exhaust from your car.
The ventilation openings of the warning device must not be covered up.
Do not spray aerosol agents in the vicinity or onto the warning device.
Do not paint the warning device.
Pictures for Installation of the Detector:
1. Holes in the ceiling (wall); 2. Wall plugs; 3. Mounting plate; 4. Screws; 5. Detector
Installing the Device onto a Wall – Description
Drill two holes (ø 5 mm) into the wall (1.); the distance between the holes should be 60 mm.
Insert the attached wall plugs (2.) into the holes, place the mounting plate (3.) and attach it to the
wall using screws (4.). Insert and connect the battery to the detector (pictures D and E) and test its
functionality; see Test Mode.
If the detector is operational, place the rear side of the detector onto the mounting plate into the
two mounting pegs and turn it.
Note:
National regulations vary in terms of the number and location of smoke detectors.
When in doubt, contact for example the fire brigade in your country.
3