Emos P56501 Manual De Instrucciones página 5

FLAT BATTERY
If the battery in the alarm is flat, it is indicated by a simultaneous beep and flash of red LED every
32 s at least 30 days before the battery runs out. Immediately replace the battery. Only use alkaline
batteries. Do not use rechargeable batteries.
Perform a functionality test.
It is recommended to replace the battery 1× a year as a precaution.
END OF SERVICE LIFE OF THE DETECTOR
The detector has a service life of 10 years since production.
After expiration, the detector must no longer be used and must be replaced with a new device.
The replacement date for the detector is listed on the label on the back, next to „Replace device".
If you are using multiple detectors, remember to check their replacement dates!
ALARM WARNING
If smoke is detected, the detector will start emitting an acoustic + optical signal.
The detector will begin continuously and simultaneously beeping (3× beeps – pause) and flashing
a red LED.
The alarm will be active until the air clears.
The acoustic signal of the alarm cannot be temporarily silenced or turned off.
If an alarm triggers, immediately evacuate the building and make sure all other people have left as well.
Do not stop to call help or pick up your things.
Contact the corresponding emergency service.
Wait until the air clears.
Do not remove the battery to stop the alarm mode – this will deactivate the alarm!
Upkeep and Maintenance
The product is designed to provide trouble-free service for many years if used properly. Here are
some tips for proper operation:
• Read the manual carefully before using this product.
• The product must be replaced with a new one after 10 years; see replacement date on the back.
• Regularly clean the product – at least 1× a month. Carefully clean any dirt and dust from ventilation
openings of the product with a vacuum cleaner.
• The product must not be painted.
• Do not expose the product to direct sunlight, extreme cold and humidity, and sudden changes in
temperature. This would reduce accuracy of detection.
• Do not place the product in locations prone to vibration and shocks – these may cause damage.
• Do not expose the product to excessive force, impacts, dust, high temperatures or humidity – these
may cause malfunction, shorter battery life, damage to batteries and deformation of plastic parts.
• Do not expose the product to rain or high humidity, dropping or splashing water.
• Do not place any open flame sources on the product, e.g. a lit candle, etc.
• Do not place the product in places with inadequate air flow.
• Do not insert any objects in the product vents, do not cover up the product.
• Do not tamper with the internal electric circuits of the product – doing so may damage the
product and will automatically void the warranty. The product should only be repaired by a
qualified professional.
• To clean the product, use a slightly moistened soft cloth. Do not use solvents or cleaning agents
– they could scratch the plastic parts and cause corrosion of the electric circuits.
• Do not immerse the product in water or other liquids.
• In the event of damage or defect on the product, do not perform any repairs by yourself. Have it
repaired in the shop where you bought it.
• This device is not intended for use by persons (including children) whose physical, sensory or
mental disability or lack of experience and expertise prevents safe use, unless they are supervised
or instructed in the use of the appliance by a person responsible for their safety. Children must
always be supervised and must never play with the device.
5