Setting The Clock; Sound Adjustments - Aiwa XR-MG9 Manual De Instrucciones

Ocultar thumbs Ver también para XR-MG9:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Setting the clock

1 Hold down SHIFT and press CLOCK on the remote
control.
When the unit is turned off, you can also press a or
ENTER.
2 Press f or g to set the time.
Each press changes the time in 1-minute steps.
Holding these buttons down will vary the time in 10-minute
units.
If f or g is not pressed within 4 seconds, setting
is canceled.
3 Press a or ENTER.
The time display stops flashing and the clock starts from
00 seconds.
To display the time while the power is on
Hold down SHIFT and press CLOCK on the remote control.
The time will be displayed for 4 seconds.
To switch to the 24-hour standard
Display the time and press s within 4 seconds.
With each press, the clock alternates between 12- and 24-
hour standard time.
Tip:
In the 12-hour standard, "AM12:00" indicates midnight and
"PM12:00" noon.
If the clock display flashes when the unit is turned
off
There has been a power interruption. Reset the clock.

SOUND ADJUSTMENTS

Equalizer
Selects a sound equalization curve to match the music type.
Press EQ (EQ/QSURROUND on the remote control)
repeatedly to select one of the three equalization
curves.
- ROCK: Powerful sound emphasizing treble and bass
- POP: More presence in the vocals and midrange
- JAZZ: Accented lower frequencies for jazz-type music
- EQ OFF: Equalizer effect is canceled.
T-BASS
Emphasizes low frequencies for a powerful sound.
Press T-BASS repeatedly to select one of the three
emphasis levels or the off position.
•If the sound becomes distorted with the T-BASS effect, cancel
the effect.
Q SURROUND system
The Q SURROUND system built into this unit uses only two
speakers at the left and right to create an atmosphere that
sounds as if you are surrounded by two front speakers and
two rear speakers.
Hold down SHIFT and press EQ/QSURROUND on the
remote control.
"ON QSURROUND" will flow from right to left.
To cancel the Q SURROUND effect
"OFF QSURROUND" flows from right to left and the
"QSURROUND" indicator goes off.
Tips:
•The Q SURROUND system does not work in monaural
mode.
•When the Q SURROUND system is on, the sound may be
distorted at higher volumes. If this happens, turn the
volume down.
En
9

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido