Programmed Playback - Aiwa XR-MG9 Manual De Instrucciones

Programmed playback

Plays back up to 30 selected tracks in programmed order.
1 Hold down SHIFT and press PROGRAM on the
remote control in stop mode.
"PRGM" flashes on the display.
2 Press the numbered buttons on the remote
control to program a track.
-To select the 25th track, press +10, +10 and 5.
-To select the 10th track, press 10.
The selected track number lights up on the display.
3 Repeat step 2 to program other tracks.
The total number of selected tracks and total playing time
will be displayed.
4 Press c to start play.
The track number for the current track flashes on the
display.
•During programmed playback, you cannot select a track with
the numbered buttons. "Can't USE" is displayed when
you try to select a track .
•It is impossible to play a selected set of tracks in random
order.
•If the total playback time of the program exceeds 99 minutes
and 59 seconds, or if a track with a track number exceeding
30 is programmed, the playing time is displayed as
"- -:- -".
•You cannot program more than 30 tracks. "FULL" is
displayed.
To check the program
Press f or g repeatedly in stop mode. The track
number and program number are displayed in succession.
To clear the program
Press s in stop mode. "PRGM" disappears on the display.
To add tracks to the program
Repeat step 2 before starting playback. The tracks are added
to the end of the program.
To change the programmed tracks
Clear the program and repeat all the steps again.
Notes on CDs
•Do not place more than one disc.
•Do not tilt the unit with a disc inserted.
•The unit may not play CD-R/RW discs recorded on personal
computers or certain kinds of CD-R/RW recorders.
•Do not attach adhesive label to either side of CD-R/RW discs,
as doing so may cause malfunction.
•Do not load an unrecorded CD-R/RW disc. The disc may be
damaged.
•Do not use irregular-shaped CDs.
En
11