Machine Operation - Clarke BextSpot Pro Spotter Instrucciones De Uso

A - ENGLISH
CARPET SPOTTER SETUP
!!! READ OPERATORS MANUAL THOROUGHLY PRIOR TO
OPERATING OR SERVICING THIS MACHINE!!!
Carefully check the shipping carton for signs of damage. Report any
carton damage to carrier immediately.
Check carton contents to ensure carton is complete. Contact your
distributor if anything is missing. Contents:

Carpet Spotter

Vacuum & Solution hoses

Hand tool

!!! READ OPERATORS MANUAL THOROUGHLY PRIOR TO
OPERATING OR SERVICING THIS MACHINE!!!
1 Using a hose or bucket, fi ll tank with a maximum of 1 gallon of
water.
!!! DO NOT USE FLAMMABLE LIQUIDS OR OPERATE MACHINE IN
OR NEAR FLAMMABLE LIQUIDS OR VAPORS!!!
2) Connect the solution hose and vacuum hose to the machine.
3) Connect the power cable to a grounded wall outlet. (see grounding
instructions)
A - 4
INSTRUCTIONS FOR USE
BextSpot Pro - 56091115

MACHINE OPERATION

PRIOR TO REMOVING SPOTS
1) Inspect power cable for damage. Replace cable if damage is
found.
2) Vacuum carpet to remove debris prior to extracting the spot.
SPOT REMOVAL
1) Turn on vacuum /pump switch.
NOTE: Solution will only spray when the spray handle(on the hand tool)
is pulled.
2) To start cleaning, pull the spray handle (hand tool) and begin to
pull the tool backwards over the spot.
3) Release spray handle when you have reached the end of the spot.
Continue to pull hand tool back for another 4 inches to pick up
excess solution.
4) Continue until spot is removed.
2/14