Tabla de contenido
Publicidad
Figure 3
Figure 4
Page
-14-
HOW TO PREPARE THE MACHINE FOR OPERATION
To prepare the machine for operation, follow this
procedure:
1. Remove tool kit from carton.
2. Remove head assembly from tank before removing
tank from carton.
3. Remove tank assembly from carton.
4. Attach head assembly to tank.
MACHINE OPERATION
If using machine for liquid pickup, follow this procedure:
1. Remove the filter bag.
NOTE:
This machine has a float shut-off.
When the water raises the float, the air
stops moving through the machine.
2. Turn machine on and begin vacuuming. The ON/
OFF switch is on top of the vacuum head assembly.
Put the switch in the "I" position to start the motor.
Put the switch in the "O" position to stop the motor.
3. When cleanup is complete, empty the liquid by
opening the drain valve on the drain hose. See
figure 3.
4. For best performance, clean the mesh screen
around the float often. See figure 4.
If using for dry pickup or to remove shampoo from
carpet, follow this procedure:
1. Use the filter bag. This will keep debris from
entering the vacuum motor.
2. Turn machine on and begin vacuuming. If pickup
efficiency decreases, stop the machine.
3. Remove the foam, liquid, dirt and carpet fibers from
the tank and from the filter bag.
NOTE:
Have an extra clean filter bag avail
able for continuous operation. Use
clean filter bag while other filter bag is
being laundered and dried.
4. For best performance, clean the mesh screen
around the float often. See figure 4.
There are no user serviceable parts. All repairs
must be done by authorized personnel only.
Clarke
Summit Operator's Manual
®
Publicidad
Tabla de contenido
