Haier HAH64EXCP Manual Del Usuario página 57

Installation
Identification Plate (located under the hob's
bottom casing)
Installing a domestic appliance it is a complicated
operation which, if not carried out correctly, can
seriously have impact on safety of goods,
properties or people. For this reason, it should be
carried out by a professionally qualified person in
accordance with technical regulations.
In the event that this advice it is ignored and
installation is carried out by an unqualified person,
the Manufacturer declines all responsibility for any
technical failure of the appliance whether or not it
results in damage of goods or properties or in
injury of people or animals.
After having removed the packaging please be
sure that the appliance it is not damaged,
otherwise contact the Retailer or Manufacturer
After Sales Service.
Make sure that the furniture in which the
appliance will be fitted and all other furniture in the
nearby are made with materi
ls which can withstand high temperatures (min
100 °C).
In addition, all decorative laminates should be
fixed with high-resistance glue.
Appliance can be installed in a Built-in furniture in
"Standard" or "Flush" mode.
560
M n. 70 mm
490 + 2 mm
- 0
Standard installation
perimeter
523 + 2 mm
- 0
Flush installation
perimeter
Product code t
+ 2 mm
- 0
Slot depth
5 mm
Note: Inner perimeter dimensions are same with
standard installation
Leave a distance of at least 55 mm between the
hob and the back wall and of at least 150 mm
between the hob and the vertical furniture or walls
in the lateral side. If a furniture is installed above
the hob, the minimum distance required is 700
mm.
When installing a hood above the hob, please
consult the installation requirements specified for
the hood but, in any case, the distance between
the hob and the hood must not be lower than 700
mm.
If the bottom part of the hob is adjacent to an area
normally accessible for handling or cleaning
operations, a separator it must be put 20 mm
below the bottom part of the hob.
GB 57
700 mm
55 mm
150 mm