Descargar Imprimir esta página

ProBreeze PB-H02 Manual De Instrucciones página 3

Ocultar thumbs Ver también para PB-H02:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 39
-
Never leave the heater unattended while in use. Always turn the heater off and unplug when
not in use.
-
Do not use the heater while sleeping or place it near a person who is sleeping.
-
Do not place this heater near flammable materials, surfaces or substances. Keep
combustible materials, such as furniture, pillows, bedding, papers, clothes, and curtains at
least 3 feet (0.9m) from the heater.
-
Use the heater in a well-ventilated area.
-
This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If
provided, use handles when moving the heater. Use gloves or oven mitts to avoid serious
injury.
-
Prior to cleaning or other maintenance, the appliance must be disconnected from the power
supply.
-
Allow the heater to thoroughly cool down before handling or cleaning.
-
Do not use any abrasive cleaners or solvents, as heater damage will occur.
-
To disconnect the heater from the mains power, first turn the controls to the OFF position
and then remove the plug from the socket.
-
Ensure the heater is switched off and the power cord is unplugged from the electrical outlet
before cleaning the heater.
-
Never insert fingers or metal objects into the vents and openings of the heater.
-
Avoid placing the power cord in areas where it can become a tripping hazard. Do not place
the power cord under carpeting or cover it with rugs, runners or similar.
-
To avoid a circuit overload when using this heater, do not operate another high-wattage
heater on the same electrical circuit.
-
Always plug the heater directly into a wall socket. Avoid using extension leads where
possible as they may overheat and cause a risk of fire.
-
Do not use this appliance with an external programmer, timer switch or any other devise
which would switch the device on automatically unless this has already been pre-built into
the appliance by the manufacturer.
-
Do not kink or wrap the power cord and plug around the appliance, as this may cause the
insulation to weaken or split, particularly where it enters the appliance.
-
Ensure the mains cable is fully extended before use and arrange it so that it is not in contact
with any part of the appliance.
-
Do not pull on the mains cable. Never move, carry or hang the appliance by the mains cable.
The heater should not be used in a room, of which the floor area is less than 5m².
-
Do not operate the appliance with any safety guards removed.
-
Do not operate the appliance if there are signs of damage to the appliance, power cord, or
any of the accessories.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a
similarly qualified person in order to avoid a hazard.
-
Do not attempt to repair or adjust any electrical or mechanical elements in the appliance.
-
Doing so may be unsafe and will void your warranty.
-
Ensure that the mains supply (including voltage, frequency and power) complies with the
rating label of the appliance.
English | 2

Publicidad

loading