Yamaha MT400 Manual De Instrucciones página 33

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
Connect AUX SENDs 1 and 2 to the inputs of
external effects processors.
2
Connect the outputs of the effects processors
to STEREO INPUTs 5L/6R or 7L/8R.
3
Set the effects processors so that they will
output only processed signals.
4
Connect sound sources to MIC/LINE INPUTs
1–4.
5
Set the [INPUT-FLIP] switches on Input
Channels 1–4 to "MIC/LINE (
6
Set the [REC SELECT] switch of a recording
track to "L" or "R".
When you are using AUX SENDs to apply effects
during track recording, the Stereo bus is used for
recording. With a direct recording setting, the
processed signal returned from the effects units to the
Stereo bus cannot be recorded.
7
Set the monitor select switch to "CUE".
A monaural CUE bus signal is used for monitoring
during normal recording. However, if you wish to
check the stereo effects sound, set the monitor select
switch to "STEREO" to listen to the Stereo bus signal.
8
Press the [PAUSE] button, then the
button.
REC
9
While playing the sound sources, use the
GAIN controls and faders on Input Channels
1–4, and the STEREO fader to adjust the
recording level.
0
Use the faders and PAN controls on Input
Channels 1–4 to achieve a mix balance
between sound sources.
A
While playing the sound sources, turn up the
AUX 1 and 2 controls of the input channels to
which you wish to apply effects.
As you turn up the AUX 1 control, the corresponding
channel signal is sent to the Stereo bus and the effects
processor connected to AUX SEND 1. Similarly, as you
turn up the AUX 2 control, the corresponding channel
signal is sent to the Stereo bus and the effects
processor connected to AUX SEND 2.
Note: The signals for the AUX 1 and 2 controls are
sourced post-fader. So, as you change the channel
faders, the degree of effects changes.
B
Adjust the input level on the effects
processors, if necessary.
C
Turn up the LEVEL control of stereo inputs 5L/
6R or 7L/8R.
The processed sound from the effects processor is
mixed into the Stereo bus signal. The more you turn
up the LEVEL control, the more the effects sound is
mixed, and the greater is the degree of effects.
)".
31
—Owner's Manual

Publicidad

Tabla de contenido
loading

Tabla de contenido