Specifications - Yamaha MT400 Manual De Instrucciones

46
Specifications
Tape Transport
Tape Type
Track Configuration
Tape Heads
Motor
Tape Speed
Pitch Control
Wow & Flutter
Rewind Time
Mixer
Frequency Response
S/N Ratio (at rated input &
output levels)
EQ
Recorder
Overall Frequency Response
Overall S/N Ratio
Overall Distortion
Erasure Rate
Noise Reduction
Connections
# of I/Os
I/O Specifications
MIC/LINE
INSERT IN CH 1, 2
STEREO IN
INSERT OUT CH 1, 2
—Owner's Manual
C46–90 cassette tapes (Type II)
4-track/4-channel, One-way Record-Play
4-track Record-Play, Hard Permalloy x 1, 4-track Erase, Ferrite x1
DC servo motor x1
4.8 cm/s, 9.5 cm/s
Approximately ±10%
0.12% WRMS (9.5 cm/s)
Approximately 120 seconds for a C60 tape
20 Hz–20 kHz, +1/–4 dB, MIC IN—STEREO OUT
65 dB/IHF-A, MIC IN—STEREO OUT (GAIN TRIM MAX)
70 dB/IHF-A, LINE IN—STEREO OUT (GAIN TRIM MIN)
Basic frequency: 80 Hz, Range: ±12 dB
LOW/Shelving
Basic frequency: 1 kHz, Range: ±12 dB
MID/Peaking
Basic frequency: 12 kHz, Range: ±12 dB
HIGH/Shelving
50 Hz–14 kHz, +3/–5 dB (9.5 cm/s, NR OUT)
80 dB/IHF-A (NR IN) [at 3% distortion level]
2.0% (400 Hz, –10 dB)
55 dB (1 kHz, 0 dB, BPF)
dbx TYPE II
MIC/LINE x4
INSERT I/O x2
STEREO IN x2
AUX SEND x2
STEREO OUT L, R x1
MONITOR OUT L, R x1
SYNC OUT x1
PHONES L, R x1
Input Impedance: 10 kΩ
Rated Input Level: –10 to –50 dB (CH fader at rated levels)
Minimum Input Level: –56 dB (Gain trim max. CH fader max)
Input Impedance: 10 kΩ
Rated Input Level: –10 dB (CH fader at rated levels)
Minimum Input Level: –16 dB (CH fader max)
Input Impedance: 10 kΩ
Rated Input Level: –10 dB (CH fader at rated levels)
Minimum Input Level: –16 dB (Volume max)
Output Impedance: 100Ω
Rated Load Impedance: 10 kΩ or higher
Rated Output Level: –10 dB (10 kΩ load)
LINE IN—MONITOR OUT