Gloria FINECUT 18V Instrucciones De Uso página 33

RZ_FineCut18V.qxp_Text_GB 06.02.23 19:42 Seite 33

store battery in a dry, elevated, closed,
frost-protected space at a tempera-
ture between 0 °C and + 45 °C. When
storage temperature is +15 °C, self-dis-
charge and chemical ageing is at its
lowest. Avoid direct sunlight.
11 Problems with the device
11.1 Troubleshooting the
Faults usually occur if the device has not been handled, cared for or maintained properly. The
following table contains the most common faults and remedies to eliminate these faults. If
you have any other problems, please contact your nearest service centre authorised by the
manufacturer, or your nearest authorised specialist dealer.
Fault
Device does not
start
Status display batt.;
4 displays flash
Status display batt.;
1 display flash
Battery charging
display continu-
ously lit, charging
is not possible
Battery charging
display does not
light up
Cutting unit
blocked
Cutting unit is
stiff
Grass is cut is too
long / too short
and the Al 1810 CV battery charger
Cause
Battery not inserted properly
Battery capacity too low
Faulty battery
Battery overheating, battery status
indicator lights up red
Temperature protection
Low voltage cutoff
Battery not inserted properly
Battery contacts dirty
Faulty battery
Mains plug for the charger has not
been plugged in (properly)
Mains outlet, power cable or char-
ger defective
Cutting unit is blocked by cut
material, twigs or foreign objects
Cutting unit is not sufficiently
lubricated
Incorrect height adjustment
33

if the battery is not used for more
than 6 months, use the status indica-
tor to check the charging status in
the charger. Recharge the battery to
approx. 40-60% capacity if required.
Remedy
Insert the battery into the holder
until it clicks into place
Charge the battery
Battery defective or at the end of its
life. Replace the battery!
Allow the battery to cool down
Allow the device and the battery to
cool down for around 5 minutes and
do not use them in that time
Charge the battery
Insert the batt. correctly into the charger
Clean the battery contacts, e.g. by
plugging in and unplugging the bat-
tery several times, if necessary
Replace the battery
Insert the mains plug (fully) into the
mains outlet
Check the mains voltage. If necessa-
ry, have the charger checked over by
an authorized repair shop for GLORIA
electrical power tools
Clean the blade on the cutting unit
and move it
Lubricate the cutting unit
Adjust the height of the wheels