Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
The machine has an automatic switch function that
lets the other battery work when the first cannot
operate.
1.
Open the battery door (9).
2.
Align the lift ribs on the battery pack (20) with the
grooves in the battery compartment.
3.
Push the battery pack into the battery
compartment until the battery pack locks into
place.
4.
When you hear a click, the battery pack is
installed.
5.
Close the battery door.
7.9
REMOVE THE BATTERY PACK
1.
Open the battery door (9).
2.
Push and hold the battery release button (19).
3.
Remove the battery pack from the machine.
8
OPERATION
WARNING
Wear eye protection during operation.
8.1
START THE MACHINE
1
2
1.
Push and hold the start button (2).
English
NOTE
2.
While you hold the start button, pull the bail
switch (1) in the direction of the handle bar.
3.
Release the start button to start the machine.
Soft-Start
This Li-ion machine has a "soft-start" feature.
When you start the machine, it goes to full speed after
approximately 3 seconds.
If the machine does not start, remove the battery
pack and examine the mower deck to make sure
that:
• no grass catches on the blade.
• the blade can turn freely by hand.
8.2
STOP THE MACHINE
1.
Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the
machine again. Do not quickly turn the machine off
and on.
Always remove the battery pack after you complete
the work.
8.3
OPERATE THE SELF-PROPEL DRIVE
SYSTEM
24
4
1.
Start the machine.
2.
While you hold the bail switch (1), turn the
StepSense self-propel button (4) to the unlocked
position to open the self-propel system.
11
NOTE
WARNING
WARNING
EN
Publicidad
