Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3.
Grab the handle (24) and push it to start self-
propel drive. The mower runs at the highest
speed when the handle is in the lowest position.
4.
Turn the StepSense self-propel button to the
locked position to close the self-propel system.
To engage the self-propel drive system while the
mower is not running:
• Turn the StepSense self-propel button to the
unlocked position.
8.4
EMPTY THE GRASS CATCHER
1.
Stop the machine.
2.
Remove the battery pack.
3.
Open the rear discharge door and hold it.
4.
Hold the grass catcher by its handle and unhook
it from the door rod.
5.
Close the rear discharge door.
6.
Empty the grass catcher.
8.5
OPERATE ON SLOPES
Do not mow on the slopes with incline more than
15°. If you are not comfortable, do not mow on a
slope.
Please keep a low self-propelled speed when you
mow on a slope.
• Do not go up and down on a slope, mow across the
face of the slope. Be careful when you change the
direction on a slope.
• Monitor the holes, ruts, rocks, and other hidden
objects that can cause you to fall. Remove all
obstacles such as rocks and tree limbs.
• Make sure that your footing is stable. If you are out
of balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or
embankments.
8.6
OPERATION TIPS
• Do not try to override the operation of the start
button or bail switch.
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning
parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick
grass.
WARNING
WARNING
English
• Clean the bottom of the mower deck after each
use. Remove grass clippings, leaves, dirt, and other
debris.
9
MAINTENANCE
Remove the battery pack from the machine before
maintenance.
Keep the motor and battery pack free from grass,
leaves or too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the
plastic housing or components.
9.1
GENERAL MAINTENANCE
• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use
water.
9.2
REPLACE THE BLADE
23
22
21
12
WARNING
WARNING
CAUTION
CAUTION
CAUTION
Publicidad
