Nuna pipa urbn Manual De Instrucciones página 11

Parts List
Make sure all parts are available before assembly. If any part is missing, please
contact local retailer. No tools are required for assembly.
1 Head support
2
Seat Pad
3 Shoulder Harness Straps
4 Infant Insert
5 Harness Adjustment Button
6 Adjustment Webbing
7 ISOFIX Connector
8 Safety Buckle
9 Side Belt Guides
10 Quick Guide Pocket
1
2
3
4
5
6
7
20
7
PIPA urbn instructions
11 Post Adapter Release Button
12 Canopy Mount
13 Canopy
14 Dream drape™ Zipper
15 Handle
16 Handle Adjustment Button
17 Rear Belt Guide
18 ISOFIX Release & Stroller
Release Button
19 Canopy Window
20 ISOFIX Guides
14
13
12
11
10
9
8
15
16
Product Use
Installation Concerns
This infant carrier is suitable for vehicle seats with i-Size ISOFIX anchor bars. (1)
This infant carrier is suitable for vehicle seats with a vehicle retractor safety belt
only. (2)
DO NOT install this infant carrier on vehicle seats with Lap Belts only. (3)
DO NOT use the rearward facing enhanced child restraint systems in seating
positions where there is an active frontal airbag installed. Death or serious injury
may occur. (4) Please refer to vehicle owner's manual for more information.
DO NOT install this enhanced child restraint on vehicle seats that face sideways
or rearward with respect to the moving direction of the vehicle. (5)
It is recommended to install this enhanced child restraint on the rear vehicle
seat. (6)
DO NOT install this enhanced child restraint on movable vehicle seats during
installation.
Canopy
1
- To assemble the canopy, slide the canopy mounts into the openings in the
seat shell. Check that the canopy is secure by pulling up on the canopy
mount. (7)
2
- Fasten the snaps on the back of the canopy soft goods on both sides. (8)
3
- Unzip the zipper behind the front canopy bow. (9)
4
- Pull the dream drape™ out of the compartment and attach the
dream drape™ to the magnets on each corner at the front of the infant
carrier. (10)(11)
5
- The canopy window can be opened for ventilation. (12)
Handle Adjustment
1
- The infant carrier handle can be adjusted to 3 positions. (13)
19
2
- To adjust the handle, squeeze handle buttons on both sides. (14)-1
3
- Rotate handle until it clicks and locks into any of the 3 positions. (14)-2
18
Be sure handle is locked in the carry position before lifting the infant carrier.
17
An unlocked handle could move unexpectedly, causing injury to child.
8
PIPA urbn instructions