Descargar Imprimir esta página

Nuna pipa urbn Manual De Instrucciones página 13

Ocultar thumbs Ver también para pipa urbn:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
Installation using ISOFIX system + 3-point-belt
Line up the ISOFIX connectors with the ISOFIX guides, and then click
both ISOFIX connectors into the ISOFIX anchor bars. (35)-1
Make sure that both ISOFIX connectors are securely attached to their
ISOFIX anchor bars. There should be two audible clicks and the colors
of the indicators on the both ISOFIX connectors should be completely
green. (35)-2
Pull the vehicle safety belt out and lock it into the vehicle buckle. (35)-3
The infant carrier cannot be used if the vehicle safety belt buckle (female
buckle end) is too long to anchor the infant carrier module securely.
(35)-4
Route the vehicle lap belt under both side guides. (35)-5
Route the shoulder belt around the back of the infant carrier passing
through the rear belt guide. (35)-6
Level line on the restraint label must be level with the ground when the
infant carrier is installed. (35)-7
Make sure the vehicle belt is as tight as possible around the infant carrier
and the belt is not loose or twisted.
After installing the infant carrier, always check that the vehicle belts are
routed correctly and securely fastened into the vehicle buckle.
Accessories
Post Adapters
The infant carrier can attach to Nuna strollers using adapters. Adapters are
included with Nuna strollers. (36)
Visit nunababy.com for more information.
Detach & Assemble Soft Goods
see images (37)-(47)
To re-assemble the soft goods, reverse the aforementioned steps.
11
PIPA urbn instructions
Cleaning and Maintenance
Clean the frame, plastic parts, and fabric with a damp cloth, but do not use
abrasives or bleach. Do not use silicon lubricants as they will attract dirt and
grime.
To ensure long-lasting use, wipe this product off with a soft, absorbent cloth
after using it in rainy weather.
Refer to the care labels attached to the soft goods for washing and drying
instructions.
It is normal for fabric to color from sunlight and to show wear and tear after a
long period of use, even when used normally.
For reasons of safety, only use original Nuna parts.
Check regularly if everything functions properly. If any parts are torn, broken,
or missing, stop using this product.
NUNA International B.V. Nuna and all associated logos are trademarks.
12
PIPA urbn instructions

Publicidad

loading