Publicidad
Idiomas disponibles
Idiomas disponibles
Hazard information
The device is not a toy: do not allow children to play with it. Do not
leave packaging material lying around. Plastic films/bags, pieces of
polystyrene, etc. can be dangerous in the hands of a child.
We accept no liability for damage to property or personal injury
caused by improper use or the failure to observe the hazard warn-
ings. In such cases, all warranty claims are void. We accept no liabil-
ity for any consequential damage.
Please note the insulation stripping length of the conductor to be
connected, indicated on the device. Permitted cable cross sections
for connecting to the device are: Rigid cable: 0.75-2.5 mm
flexible cable without ferrule: 0.75-2.5 mm
During installation, ensure safe isolation between the mains voltage
and Ethernet as well as between Ethernet and DALI. The DALI control
voltage (B) is a functional extra-low voltage (FELV). The Ethernet
cable (F) is a SELV power circuit. This wire must be separated from
mains voltage cables and from the DALI bus by safe separation
measures (e.g. with horizontal and vertical separators).
The network terminals may be used only for connecting the power
supply to the device or for connecting loads to the device. The
connection (looping through) of conductors via the network
terminals of the device to other devices is not permitted!
The circuit to the which the device and the load will be connected
has to be secured by a cable protection switch in accordance with
EN60898-1 (tripping characteristic B or C, max. 16 A rated current,
min. 6 kA interrupting rating, energy limiting class 3). Installation
regulations according to VDE 0100 and HD382 or 60364 have to be
considered.
During installation, ensure safe isolation between the mains voltage
and Ethernet as well as between Ethernet and DALI. The DALI con-
trol voltage is a functional extra-low voltage FELV.
30
2
2
Publicidad
