Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 4
Fig. 5
1
2
3
4
1
2
Upper limit
3
Lower limit
4
USING THE RIGHT OIL
Use a high-qualitySAE 10W-30 weight oil. DO NOT use
dirty oil. Failure to use clean oil of the correct type can
cause premature engine wear and failure.
FUELING THE UNIT
WARNING:
Gasoline is extremely flammable. Ignited vapors may
explode. Always stop the engine and allow it to cool
before filling the fuel tank. Do not smoke while filling the
tank. Keep sparks and open flames at a distance from
the area.
Remove the fuel cap slowly to avoid injury from fuel
spray. Never operate the unit without the fuel cap secu-
rely in place.
Add fuel in a clean, well-ventilated outdoor area. Wipe
up any spilled fuel immediately. Avoid creating a source
of ignition for spilled fuel. Do not start the engine until
fuel vapors dissipate.
WARNING:
Gasoline and its vapors are highly flammable and ex-
plosive. To prevent serious injury and property damage,
handle it with care. Keep away from ignition sources
12
ASSEMBLY
and open flames, handle outdoors only.
Pour fuel outdoors where there are no sparks or flames.
Slowly remove the fuel cap after stopping the engine.
Do not smoke while fueling. Wipe spilled fuel from the
unit. Move at least 3 m (10 ft) away from the fueling
source before starting the engine.
WARNING:
Always wear heavy, long pants, boots, gloves, and a
long-sleeve shirt. Do not wear loose clothing, jewelry,
short pants, sandals, or go barefoot. Secure hair so it is
above shoulder level.
1. Position the unit with the fuel cap facing up.
2. Slowly remove the fuel cap.
3. Place the fuel container spout into the fuel tank fill
hole and fill the tank. Stop adding fuel when you see
that the level reaches the base of the tank spout
(Fig. 6).
4. Wipe up any fuel that may have spilled.
5. Reinstall the fuel cap.
6. Move the unit at least 3 m (10 ft) from the fuel contai-
ner and the fueling site before starting the engine.
Fig. 6
1
1
Base of the tank spout
www.senixtools.com
Publicidad
