Senix TL4QL-L1 Manual Del Operador página 15

Fig. 12
HOLDING THE UNIT
• Stand in the operating position (hold the machine in
front of your body). Stand up straight. Do not bend
over.
• Keep feet apart and firmly planted.
• Hold the handle with two hands. Keep the arms
straight.
• Do not over-reach; Keep all parts of your body away
from the rotating cutting attachment and hot surfaces.
WARNING:
Do not operate the machine with a damaged or excessi-
vely worn cutting device.
CLEARING JAMS
If the blades get jammed by a wire or other obstruction
and cannot move, follow these important safety rules:
• NEVER reach for, or try to remove, jammed material
while the engine is running.
• ALWAYS switch the unit off and wait for blades to stop
before clearing a jam.
• ALWAYS inspect the blades after clearing a jam to
make sure all jammed material has been cleared, and
to make sure blades are not damaged.
www.senixtools.com
OPERATION
15