Senix TL4QL-L1 Manual Del Operador página 20

PROBLEM
THE ENGINE WILL NOT START.
The fuel tank is empty.
The primer bulb was not pressed enough.
The fuel is old (over 30 days).
The spark plug is fouled.
THE ENGINE WILL NOT IDLE.
The fuel is old (over 30 days).
Idle speed screw needs adjustment.
THE ENGINE EMITS TOO MUCH SMOKE.
Too much oil in crankcase.
THE ENGINE WILL NOT ACCELERATE.
The fuel is old (over 30 days).
The cutting blades is bound with any objects.
THE ENGINE LACKS POWER OR STALLS.
The fuel is old (over 30 days).
The spark plug is fouled.
UNSATISFACTORY CUTTING PERFORMANCE.
Cutting blade is dull/damaged.
Cutting material exceeds capacity.
EXCESSIVE VIBRATION/NOISE OR EXHAUST.
Bolts/Nuts are loose.
Gas/oil is incorrect.
20
TROUBLESHOOTING
SOLUTION
Fill the fuel tank with fresh fuel.
Press the primer bulb 10 times.
Drain the fuel tank and add fresh fuel.
Replace the spark plug.
Drain the fuel tank and add fresh fuel.
Turn idle speed screw clockwise to increase idle speed.
lubricant.
Drain the fuel tank and add fresh fuel.
Stop the engine and clean the cutting blades.
Drain the fuel tank and add fresh fuel.
Replace the spark plug.
Only cut material according to the capacity of the unit.
Tighten.
www.senixtools.com