Publicidad
Idiomas disponibles
Idiomas disponibles
ONCE WARMING CYCLE IS COMPLETE
CAUTION: BOTTLE WARMER TANK WATER MAY BE HOT: CAREFULLY REMOVE
THE BOTTLE, MILK BAG, OR FOOD JAR IMMEDIATELY AFTER WARMING CYCLE IS
COMPLETED.
ALWAYS CHECK THE TEMPERATURE OF THE CONTENTS BEFORE SERVING:
FOR FEEDING BOTTLES AND MILK BAGS:
Gently shake or stir the contents to ensure the temperature is even; check
the temperature by squeezing a few drops onto the inside of your wrist.
FOR FOOD JARS:
Stir the contents of the jar to make sure the temperature is even; check the
temperature by tasting.
• For best results, allow the bottle warmer to cool completely (approx. 30 mins.)
before starting a new warming cycle.
• If you have twins, the Bottle Warmer can be used for two consecutive warming
cycles by removing the plug from the wall outlet and carefully emptying the hot
water and replacing it with room temperature water. After plugging in the warmer
and turning it back on, simply touch the START/STOP button to begin reheating
using the previous settings stored in memory.
• When warming Milk Bags and Jars from frozen, you may need to run a second cycle.
The initial default warming time should be decreased as needed to prevent
overheating during the second cycle.
• If the jar contents are not warm enough, repeat warming cycle until desired
temperature is reached. When repeating a cycle, check the temperature of contents
at regular intervals to avoid overheating. The initial default warming time can also
be decreased as needed to prevent overheating during the second cycle.
• When finished, remove the plug from the wall outlet. Do not leave cord within
child's reach. Allow the tank to cool down completely before pouring out the
water. Dry the inside thoroughly.
14
DELAYED START
The warming cycle can be delayed
for up to 60 mins. before
beginning the cycle.
Before touching the START/STOP
button (to start the warming
cycle), touch the DELAYED START
button. Adjust the time by
pressing the "+" and "-" buttons.
The delayed start can be set for
15 mins., 30 mins., 45 mins.,
and 60 mins.
Then touch the START/STOP
button to start the warming
cycle with a delay. The timer will
countdown and then the cycle will
begin.
The delay can be skipped at any
point by touching the START/
STOP button again to run the
cycle immediately.
15
Publicidad
