Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL
1. Double check that accessories or application tools are
properly fixed.
2. Always hold the product on its handle. Keep the handle
dry and clean to ensure safe support.
3. Ensure that the air vents are always unobstructed
and clear. Clean them if necessary with a soft brush.
Blocked air vents may lead to overheating and damage
the product.
4. Switch the product off immediately if you are disturbed
while working by other people entering the working
area. Always let the product come to a complete stop
before putting it down.
5. Do not overwork yourself. Take regular breaks to ensure
you can concentrate on the work and have full control
over the product.
6. Before switching the product on, check whether it has
been assembled correctly and all the moving parts are
running smoothly!
7. While working, ensure that the product does not strike
hard objects, as this can cause damage.
8. Do not blow any solid bodies such as stones, branches,
pieces of branch or similar.
9. We recommend slightly dampening surfaces in dusty
conditions or using a mister attachment.
NOTE:
The risk of the operation may occurs, such as the sharp
tree branches may cut the user's skin, the blade of the unit
may hurt the user's body. Always wear eye, hearing, hand,
foot and body protection to reduce the risk of injury when
operating this unit.
BLOWING
1. Before blowing, loosen leaves that are stuck to the
ground using a broom or rake.
2. Hold the tube approximately 3.9inch(10cm) above
the ground and walk slowly forward using a sweeping
motion from side to side.
3. Direct the air stream away from yourself.
4. Ensure that you do not stir up any heavy objects and
hurt somebody or damage something.
NOTE:
When the blower vibrates abnormally, immediately shut
off the unit. Abnormal vibration often shows a mechanical
problem and continues use could result in injury or property
damage.
EN - 12
CHARGING THE BATTERY PACK
WARNING!
This Lithium-Ion battery pack is shipped partially
charged. Fully charge the battery pack before
using it for the first time.
NOTE:
Charge batteries at a ambient temperature of 32°F-104°F
(0°C-40°C) and always store batteries at a ambient
temperature of 32°F-77°F (0°C-25°C).
1. Charge the Lithium-Ion battery pack only with the correct
charger.
2. Connect the charger to a power supply, the light indicator
of the charger turns red.
3. Align the raised ribs of the battery pack with the slot in
the charger.
4. Insert the battery pack into the charger, the light indicator
of the charger turns green and it flashes (Fig.5).
5. The charger will communicate with the battery pack to
evaluate the condition of the battery pack.
6. It is fully charged that the four lights of the battery turn
on. Disconnect the power supply from the charger.
Remove battery pack from the charger.
CHARGING INDICATOR
Press the light button on the battery pack to check whether
it needs to charge (Fig.6) .
Lights
Lighted
Off
Blinking
Status
The battery is at full
capacity.
The battery is at 75%
capacity.
The battery is at 50%
capacity and requires
charging.
WWW.SENIXTOOLS.COM
Publicidad
