Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
OBJ_BUCH-2057-001.book Page 20 Wednesday, November 6, 2013 8:39 AM
20 | English
Changing the Blade (see figures C1
Note: Replace the blade only when the cutting adapter is mounted on the
screwdriver. This ensures that the tool spindle is locked and the blade
screw can be loosened.
– Set the rotational direction switch 6 to the middle position.
– Unscrew the blade screw 7 in rotation direction .
– Lightly lift the blade 8 and pull it down and out.
– Attach the new blade onto the tool holder ensuring that the ground
edge of the blade faces you.
Pay attention that the blade engages onto the tool holder.
– Retighten the blade screw 7 in rotation direction .
Operation
Starting Operation (see figure D)
– To set right rotation on the screwdriver, press the rotational direction
switch all the way in from the right.
The indicator for right rotation lights up when the On/Off
switch 5 is actuated and the motor is running.
– To start the cutting adapter, press the On/Off switch 5 of the screw-
driver and keep it pressed.
Working Advice
Do not strain the machine so heavily that it comes to a standstill.
The cutting performance of the machine depends on the materials to be
cut and on the charging condition of the battery.
Depending on the charge condition of the battery, excessive feed consid-
erably reduces the performance capability.
Always keep the blade free and clean of material remainders.
The guide edge 2 may not become wedged during cutting and must be
aligned parallel to the cutting surface.
Improper use of the blade will cause it to become blunt.
Thin materials, such as fabrics, can be pulled into the machine during cut-
ting and become wedged. Therefore, do not apply too much pressure with
such materials in order to achieve good cutting results. During cutting, ap-
ply sufficient tension while holding fabrics and cut slowly.
Optimum cutting results are best determined through practical testing.
2 609 007 546 | (6.11.13)
C2)
–
Bosch Power Tools
Publicidad
