Descargar Imprimir esta página

Orbegozo CTP 5050 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

CTP 5050
10. Make sure the appliance has been unplugged before
cleaning.
11. This appliance must be installed following the national
regulations for electrical installations.
12. This appliance is for household use only.
13. In case that you need a copy of the instruction manual,
you can ask for it writing an email to sonifer@sonifer.es.
14. WARNING: In case of misuse, there is a risk of possible
injury.
• Only dry hair should be cut with this machine.
• Only use the machine for cutting hair.
• Do not use this appliance near bathtubs, showers, basins
or other vessels containing water.
• This device is only intended for cutting animal's hair.
PARTS IDENTIFICATION
1. Oil
2. Brush
3. Straight hair comb
4. Curl hair comb
5. Hair clipper
6. Three combs
7. Scissors
INSTRUCTIONS TO USE
1. Comb your pet's hair.
2. Remove the blade protection
cover.
3. Put some oil on the blades.
4. Depending on the hair length, set some cutting lines. If you are not sure about your cutting length, start
with 8 mm.
5. Plug in the hair clipper to 230V~50Hz.
WARNING:
Do not operate the hair clipper more than 15 minutes. Leave it stopped 10 minutes before operating it again.
BLADE CARE
Please, clean the blade after use to protect it appropriately.
6

Publicidad

loading