Keysight Technologies U1241C Guia Del Usuario página 101

4 The elapsed time is shown on the secondary display. Press
– Changing the range manually will also restart the recording session.
NOTE
– The multimeter beeps when a new maximum or minimum value is recorded.
– If an overload is recorded, the averaging function will be stopped. OL is
– The auto power-off (APO) function is disabled when MaxMin is enabled.
– The maximum recording time is 19999 seconds (5 hours, 33 minutes,
This mode is useful for capturing intermittent readings, recording minimum and
maximum readings unattended, or recording readings while equipment operation
keeps you from observing the multimeter display.
The average value displayed is the true arithmetic mean of all readings taken
since the start of recording. The average reading is useful for smoothing out
unstable inputs, calculating power consumption, or estimating the percentage of
time a circuit is active.
Keysight U1241C/U1242C User's Guide
the recording session.
shown in place of the average value.
19 seconds). OL is shown if the recording exceeds the maximum time.
Multimeter Features
Log
to restart
Hold
3
101