Keysight Technologies U1241C Guia Del Usuario página 87

Figure 2-24
– To avoid blowing the multimeter's 440 mA fuse, use the
CAUTION
– Placing the probes across (in parallel with) a powered circuit when a lead
NOTE
Press
Refer to "Measuring Frequency" on page 75.
Keysight U1241C/U1242C User's Guide
DC current display
only if you are sure the current is < 440 mA. See Figure 2-27 for test lead
connections and function selection. Refer to the Alerts and warnings
d uring measurement section for information on the alerts the multimeter
uses for hazardous current or when leads are not used correctly during
current measurement.
is plugged into a current terminal can damage the circuit you are testing
and blow the multimeter's fuse. This happens because the resistance
through the multimeter's current terminals are very low, resulting in a
short circuit.
MaxMin
to enable the frequency test mode for current measurements.
Hz
Making Measurements
terminal
2
87