Keysight Technologies U1241C Guia Del Usuario página 26

1 Introduction
To avoid damage from battery leakage:
CAUTION
– Always remove dead batteries immediately.
– Always remove the batteries and store them separately if the multimeter
Turn on your multimeter
To power ON your multimeter, turn the rotary switch to any position other than
briefly on the primary display and secondary display respectively.
Model number
Figure 1-1
To power OFF your multimeter, turn the rotary switch to the
Automatic power off
Your multimeter automatically turns off after 15 minutes (default) if:
– the rotary switch is not moved, or
– a key is not pressed, or
– dynamic recording mode is disabled.
26
is not going to be used for a long period.
. The model number and firmware version of your multimeter will be shown
Start-up display
Keysight U1241C/U1242C User's Guide
Firmware version
position.