Keysight Technologies U1241C Guia Del Usuario página 102

3 Multimeter Features
Freezing the Display (TrigHold and AutoHold)
TrigHold operation
Press
– the AH (AutoHold) Setup menu entry is disabled (refer to "Changing the
– the multimeter is not in the MaxMin or data logging recording modes.
To exit, press
In the TrigHold mode, press
measured value. The
AutoHold operation
Press
– the AH (AutoHold) Setup menu entry is enabled (refer to "Changing the
– the multimeter is not in the MaxMin or data logging recording modes.
To exit, press
The AutoHold operation monitors the input signal and updates the display and, if
enabled, emits a beep, whenever a new stable measurement is detected. The
icon flashes before the display is updated. The AutoHold mode will be triggered
when the input signal varies more than a selected adjustable (AutoHold threshold)
variation count (default 50 counts).
To change the default AutoHold threshold count, refer to "Changing the variation
count" on page 119.
102
Log
to freeze the display for any function only if:
Hold
variation count" on page 119).
View
for > 1 second.
Shift
Esc
Log
to activate the AutoHold mode only if:
Hold
variation count" on page 119).
Log
again or press
Hold
Log
to manually trigger the holding of the next
Hold
icon flashes before the display is updated.
View
Shift
Esc
Keysight U1241C/U1242C User's Guide
for > 1 second.