SPORT-ELEC Selection 6 Beaute Manual De Utilización página 8

6°
START OF SESSION
Make sure that the power buttons are set at minimum (pushed to the left). Set the SPORT-ELEC
Selection 6 Beauté switch to «I».
7°
SELECT YOUR PROGRAM USING THE "PROGRAMME" BUTTON
P1 : WELL-BEING (Frequency: 1 - 13 Hz)
Your muscles prepare for effort and warm up. You are now ready to move on, either to muscle building,
or to your favourite sport.
P2 :ENERGY (Frequency: 3 - 60 Hz)
This programme helps you to efficiently firm up your body after a period of inactivity and
maintain tissue firmness.
P3 : FITNESS (Frequency: 3 - 100 Hz)
Harmonises your silhouette. This programme is ideal for working specifically on the zone that
you want to reshape.
P4 : RELAXATION (Frequency: 40 - 100 Hz)
Programme delivering a current reducing feelings of muscular tension.
8° ADJUSTING INTENSITY:
Gently turn the button for channel A from left to right, you will begin to feel contractions,
increase power as necessary. The contractions must be firm but never painful. Proceed in the
same way for the power-on button for channel B.
If you feel an unpleasant sensation around the électrodes: bring the power-on buttons back to
minimum, move the electrode(s) and gradually increase the power. Once the adjustments have
been optimised in this way, leave your appliance to work for the full duration of the programme.
9°
At the end of the session, put the power buttons on the minimum position and set the switch to «O».
Disconnect the electrodes, remove them gently, wet them slightly with a few drops of water and
place them carefully on their support. Store the electrodes in a cool dry place.
Store the SPORT-ELEC Selection 6 Beauté in its holdall.
10° SAFETY INSPECTION - Inspect the following points every 24 months :
1. Check if there is any surface damage.
2. Check if the unit is operating correctly :
* the writing on the housing must be legible
* check the switch and contactor.
3. Check if the accessories are reliable
* condition of the electrode wires
* condition of the electrodes (no tears or material defects).
4. Measure the electrical values
* under a load of 500 ohms, the peak voltage at the output must not exceed 100V.
1 1°
E
NVIRONMENT CONDITIONS FOR TRANSPORT AND STORAGE
- Ambient temperature: + 10 to + 40°C
- Relative humidity: 30 - 75%
- Pressure: 700 hPa.
:
- 14 -
12°
ADVICE FOR USE :
- Do not exceed 30 minutes of muscle work per area and per day.
- For optimum use, get ideas from the diagrams shown in this brochure.
- You can, if you wish, have two 15-minute sessions, changing the area of the electrodes; for example,
15 minutes for the abdominal muscles and 15 minutes for the buttocks.
- Store the electrodes in their original packing in a cool place
- The electrodes have a life of approximately 60 uses. Do not hesitate to order them directly from our
head office :
SPORT-ELEC S.A., ROUTE DE ROUEN - B.P. 35
27520 BOURGTHEROULDE
Tél. : 02.32.96.50.50. / Fax : 02.32.96.50.59
www.sport-elec.com / email : info@sport-elec.com
or contact your local supplier.
Technical features of the
SPORT-ELEC Selection 6 Beauté
- Two phase current
- 1 programme selection button : 4 pre-set programmes.
- Pulse frequencies between 10 and 100 Hz
- Pulse width between 160 and 320 µs
- Contraction duration set from 1.2 s to 12s.
- Intensity : Adjustable, 2 independent generators
Power supply : 2 9-Volt batteries, type 6LR61 (not provided)
DIMENSIONS : 132x59x23 mm
WEIGHT : 140 g
Classification type BF
86 Vcc/500 Ω
Warning : read instructions carefully
REGISTERED DESIGN. Europe design application
- Made in France
(89/336/CEE)CEM
Recommendations :
- The apparatus and electrodes present no environmental hazard
and can safely be disposed of in household refuse.
- The used batteries should be disposed of in existing collecting systems or
special containers.
INSERTION OF BATTERIES :
connect the tags to the batteries and insert
the back of the battery by pressing with the
thumb. Follow these instructions in the
order given to avoid damaging the tags.
- 15 -
- 15 -