Publicidad
3.5 220/110 Volt installation
The on-board 220 or 110 V installation is protected by a circuit breaker and fitted with a
residual current device. The wiring of additional 220 or 110 V on-board accessories must
be carried out by professionals, with uprating of the master circuit-breaker if necessary.
Your boat is not supplied with a shore/boat supply cable or a male plug for the shore
outlet.The cable must be suitable for outdoor use. Its cross-sectional area must be
adjusted according to its length and the rating of the main circuit-breaker (see electrical
diagram). The plug must be suitable for the female socket on the shore (if necessary,
seek the advice of a professional)It should be as near as possible to the IP 67 / IEC529
type
-
Switch off the shore supply at the on-board isolator before connecting or
disconnecting the shore/boat supply cable.
-
Connect the shore/boat supply cable at the boat end before connecting it to
the shore outlet
-
Disconnect the shore/boat supply cable at the shore outlet before
disconnecting it at the boat end
-
Close the shore outlet cover properly
ENGLISH 02-11-02
DUFOUR 40
DANGER
DANGER
Page 9
Publicidad
