Beko WMP 8744 XD Manual Del Usuario página 65

1. Close the taps.
2. Remove the nuts of the water intake hoses to access the filters on the water intake valves. Clean them
with an appropriate brush. If the filters are too dirty, remove them from their places with a pliers and
clean in this way.
3. Take out the filters on the flat ends of the water intake hoses together with the gaskets and clean
thoroughly under running water.
4. Replace the gaskets and filters carefully and tighten their nuts by hand.
4.4.5 Draining remaining water and cleaning the pump filter
The filter system in your product prevents solid items such as buttons, coins and fabric fibers clogging the
pump impeller during draining of washing water. Thus, the water will be drained without any problem and the
service life of the pump will extend.
If the product fails to drain water inside it, the pump filter is clogged. Filter must be cleaned whenever it is
clogged or in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the product (e.g., when moving to another house) water should be drained
completely.
A
WARNING:
WARNING:
inside the product must be drained when the product is not in use.
WARNING:
In order to clean the dirty filter and drain the water:
1 Unplug the product to cut off the supply power.
A
WARNING:
filter after the water inside the product is cooled down.
2 Open the filter cover.
3 Follow the below procedures in order to drain water.
If the product does not have an emergency water drain hose, in order to drain the water:
4 Clean any residues inside the filter as well as fibers, if any, around the pump impeller region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If it is one piece, seat
the tabs in the lower part into their places first, and then press the upper part to close.
Washing Machine / User's Manual
Foreign substances left in the pump filter may damage your product or may cause noise problem.
In regions where freezing is possible, the tap must be closed, system hose must be removed and the water
After each use, turn off the tap to which the mains hose is connected.
Temperature of the water inside the product may rise up to 90 ºC. To avoid the risk of scalding, clean the
a. In order to collect the water to flow out of the
filter, place a large vessel in front of the filter.
b. Turn and loosen the pump filter until water starts
to flow (counterclockwise). Fill the flowing water
into the container you have placed in front of
the filter. Always keep a piece of cloth handy to
absorb any spilled water.
c When the water inside the product is finished,
take out the filter completely by turning it.
65 / EN