Sea-Bird Scientific SBE 25plus Sealogger CTD Manual Del Usuario Básico página 3

Table of Contents
1 Sealogger quick start guide
2 Specifications on page 3
Section 1 Sealogger quick start guide
This quick start guide and user manual applies to the SBE 25plus Sealogger.
The full user manual, with details about setup, operation, and maintenance can be found on the
manufacturer's website. Refer to the full user manual for details about the topics shown in
italics.
What's in the box:
• CD—has software, calibration files, documentation
• Dummy plug and lock collar
• Data I/O cable to connect the sensor to a PC
• Spare hardware and O-ring kit.
1. Install the manufacturer-supplied software on a PC. Refer to Install software and set up sensor for
details.
2. Connect the data I/O cable to the sensor and the PC and double-click on SeaTermV2.exe to start
the software.
3. Set up the sensor for deployment.
a. If necessary, install the 12 D-cell alkaline batteries.
b. If necessary, make sure that all data stored in the sensor is transmitted to a PC.
c. Set the date and time and configure the data collection settings.
d. Send the DS and DC commands to verify setup.
4. Remove the yellow protective label from the plumbing intake and exhaust.
5. Deploy the sensor. For most applications, make sure the connector is at the bottom (lowest
point).
6. Immediately after the sensor is recovered from a deployment:
a. Transmit data from the sensor to a PC. Refer to Transmit and convert data for details.
b. Use the software to turn off the sensor.
c. Flush the sensor with fresh water.
d. Keep the sensor out of direct sunlight between deployments.
7. Refer to Recover sensor from deployment for details to prepare the sensor for short- or long-term
storage.
Section 2 Specifications
2.1 Mechanical
Weight, 600 m, plastic, in air,
water
20.0, 11.5 kg
on page 3
Weight, 6800 m, titanium, in air,
water
22.5, 13.5 kg
3 Replace batteries on page 7
4 General information on page 9
6.7, 5.9 kg
Cage, in air, water
English 3